# NVRAM file for CYW943439WLPTH
# 2.4 GHz, 20 MHz BW mode

# The following parameter values are just placeholders, need to be updated.
NVRAMRev=$Rev: 726808 $
manfid=0x2d0
prodid=0x0727
vendid=0x14e4
devid=0x43e2
boardtype=0x0887
boardrev=0x1101
boardnum=22
macaddr=00:90:4c:2d:a0:05
sromrev=11
#boardflags=0x00404201
boardflags=0x00404001
boardflags3=0x04000000
xtalfreq=37400
nocrc=1
ag0=255
aa2g=1
ccode=ALL

pa0itssit=0x20
extpagain2g=0
#PA parameters for 2.4GHz, measured at CHIP OUTPUT
pa2ga0=-168,6777,-789
AvVmid_c0=0x0,0xc8
AvVmidIQcal=0x2,0xa8
cckpwroffset0=5

# PPR params
maxp2ga0=74
txpwrbckof=6
cckbw202gpo=0
legofdmbw202gpo=0x88888888
mcsbw202gpo=0xaaaaaaaa
propbw202gpo=0xdd

# OFDM IIR :
ofdmdigfilttype=18
ofdmdigfilttypebe=18
# PAPD mode:
papdmode=1
papdvalidtest=1
pacalidx2g=45
papdepsoffset=-30
papdendidx=58

# LTECX flags
ltecxmux=0
ltecxpadnum=0x0102
ltecxfnsel=0x44
ltecxgcigpio=0x01

il0macaddr=00:90:4c:c5:12:38
wl0id=0x431b

deadman_to=0xffffffff
# muxenab: 0x1 for UART enable, 0x10 for HOST WAKE INT enable, 0x11 for both enable
# Power cycle required if change
muxenab=0x1
# CLDO PWM voltage settings - 0x4 - 1.1 volt
#cldo_pwm=0x4

#VCO freq 326.4MHz
spurconfig=0x3

#SW based desense - Enable by default
#i.e using glitich statistcs as critria to change crsmin
glitch_based_crsmin=1

# Default btc_mode
btc_mode=0
bt_default_ant=0

#Antenna diversity
#swdiv_en=1
#swdiv_gpio=2 

tempbased_duty_cycle_en=0